Atop-technology SE8502-M12 User Manual Uživatelský manuál stáhnout pdf (Strana 9)

User manual Version 1.1

SE8502-M12 IP68 Serial Server

RJ-45

Pin 1 2 3 4 5 6 7 8

Signal

Rx+ Rx- Tx+

Tx-

2. Software Setup

Now the SE8502-M12 hardware is installed and power is on, network IP configuration will be set in this

section.

2.1. Default Settings

The SE8502-M12 has an IP addresses one for Ethernet interface. These default settings are shown from under

information

Default IP addresses

Interface Device IP Subnet mask Gateway IP

LAN port 10.0.0.50.100 255.255.0.0 10.0.0.254

The other default settings of SE8502-M12 are shown in the following table

Property Default Value

Ethernet Port

IP Address 10.0.50.100

Gateway 10.0.0.254

Subnet Mask 255.255.0.0

Securit

User Name

Admin

Password Null (Leave it blank)

Serial

COM 9600/None/ 8/1,No flow control, packet delimiter disabled

Link Mode TCP Server, Listen port 4660/4661,No Filter, Virtual COM disabled

SNMP

SysName of SNMP Name (System Name)

SysLocation of SNMP Location (System Location)

SysContact of SNMP Contact (System Contact)

Table 1. Default settings of the SE8502-M12 device

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 61 62

Žádné komentáře

Atop-technology SE8502-M12 User Manual Uživatelský manuál Strana 9